tag:blogger.com,1999:blog-3035701681809038382.post5411909097090797861..comments2023-03-09T02:43:49.775-08:00Comments on retro shaper...: "Whole nutha level"Tony Lewishttp://www.blogger.com/profile/05493546121019176506noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-3035701681809038382.post-75540852050562195812009-05-05T08:28:00.000-07:002009-05-05T08:28:00.000-07:00Hey guys, thanks for that. I am using resin tint a...Hey guys, thanks for that. I am using resin tint and a brush, two coats because its black, right on to the foam.<br />I will order up some bamboo from GL, I have ordered from them before but the products were pretty low quality. <br />I don't have a good balsa source thats close by but I did have a few panels left over from a longboard build a few months back.Tony Lewishttps://www.blogger.com/profile/05493546121019176506noreply@blogger.comtag:blogger.com,1999:blog-3035701681809038382.post-60883054629659549902009-05-05T08:06:00.000-07:002009-05-05T08:06:00.000-07:00oh - if you use your home made logo over sprayed c...oh - if you use your home made logo over sprayed color, trim away as much excess paper as possible, even the best paper will not go completely clear. The darker the color, the more the paper shows. Best to put the logo on clear portions of the board.6ftnperfecthttps://www.blogger.com/profile/07525038410289177242noreply@blogger.comtag:blogger.com,1999:blog-3035701681809038382.post-58301331076720630372009-05-05T08:03:00.000-07:002009-05-05T08:03:00.000-07:00rice paper - art store or Foam-EZ
printer - inkjet...rice paper - art store or Foam-EZ<br />printer - inkjet<br />print method - print out test on 8 1/2 x 11. Then take smaller piece of rice paper and carefully tape to test sheet, run it through again at high quality. Print on the smooth side, not the rough.<br /><br />Any translucent thin art paper MIGHT work. Do a test.<br /><br />Bamboo panels:<br /><br />http://stores.greenlightsurfsupply.com/Detail.bok?no=846ftnperfecthttps://www.blogger.com/profile/07525038410289177242noreply@blogger.com